If the electronic control board fails, the washer may not power up or display the cycle status. Additionally, it might fail to fill, agitate, spin, or drain. In some cases, a shorted board may emit a burning smell. This error code is for washers with a digital display only. Check the resistance through the temperature sensor circuit. It should be around 50,000 ohms at room temperature.
Unplug the washer and disconnect the fill hoses from the back of the washer. Check for proper water flow through the fill hoses. If water flow is inadequate, have a plumber repair the water supply to the faucets.
Unexpected appliance breakdowns come with scary costs attached to them. And in the case of a Frigidaire washer, replacing it can leave quite a big hole in your pocket and is often not a feasible option. That’s why troubleshooting the issue promptly can not only save time but also save you from a big outlay of cash. For starters, examine the power cord and make sure your washer is getting an adequate power supply. If all looks good, check for tripped circuit breakers on the control board. You need to examine the drain for clogs to understand why the washer is not draining water.
If your Frigidaire washer won’t start, it might be displaying an error code. These codes are designed to help you identify the problem and take appropriate action. Check your washer’s user manual or do a quick online search to frigidaire freezer find out what the error code means. If your Frigidaire washer beeps but won’t start it could be because the water isn’t filling. First, check to make sure the water supply is turned on and the water pressure is sufficient.
If it doesn’t spin freely, replace the drive motor. If the motor spins freely, rotate the large drive pulley on the back of the washer tub to check the spin bearing. If the pulley doesn’t spin freely then the outer tub and spin frigidaire freezer basket usually need to be replaced. If the spin bearing is sound, check the resistance of the motor windings for a reading between 4 and 6 ohms. If the motor is sound, the speed control board usually needs to be replaced.